收藏本站
LSN2 Series
Non-isolated, DOSA-SIP, 6/10/16A
Selectable-Output DC/DC Converters
Notice in the simpli?ed Sequence/Track equivalent circuit (Figure 15) that
a blocking diode effectively disconnects this circuit when the Sequence/
Track pin is pulled up to +V IN or left open.
Power Good Output
The Power Good Output consists of an unterminated BSS138 small signal
?eld effect transistor and a dual window comparator input circuit driving the
gate of the FET. Power Good is TRUE (open drain, high impedance state) if the
converter’s power output voltage is within about ±10% of the setpoint. Thus,
the PG TRUE condition indicates that the converter is approximately within
regulation. Since an overcurrent condition occurs at about 2% output voltage
reduction, the Power Good does not directly measure an output overcurrent
condition at rated maximum output current. However, gross overcurrent or
an output short circuit will set Power Good to FALSE (+0.2V saturation, low
impedance condition).
Figure 15. Sequence/Track Simpli?ed Equivalent Schematic
[6] Allow the converter to eventually achieve its full-rated setpoint output
voltage. Do not remain in ramp up/down mode inde?nitely. The converter
is characterized and meets all its speci?cations only at the setpoint
voltage (plus or minus any trim voltage). During the ramp-up phase, the
converter is not considered fully in regulation. This may affect perfor-
mance with excessive high current loads at turn-on.
[7] The Sequence is a sensitive input into the feedback control loop of the
converter. Avoid noise and long leads on this input. Keep all wiring very
short. Use shielding if necessary. Consider adding a small parallel ce-
ramic capacitor across the Sequence/Track input (see Figure 14) to block
any external high frequency noise.
[8] If one converter is slaving to another master converter, there will be a very
short phase lag between the two converters. This can usually be ignored.
[9] You may connect two or more Sequence inputs in parallel from two
converters. Be aware of the increasing pull-up bias current and reduced
input impedance.
[10] Any external capacitance added to the converter’s output may affect
ramp up/down times and ramp tracking accuracy.
Figure 16. Equivalent Power Good Circuit
Using a simple connection to external logic (and returned to the converter’s
Common connection), the Power Good output is unterminated so that the user
may adapt the output to a variety of logic families. The PG pin may therefore
be used with logic voltages which are not necessarily the same as the input
or output power voltages. Install an external pullup resistor to the logic supply
voltage which is compatible with your logic system. When the Power Good is
out of limit, the FET is at saturation, approximately +0.2V output. Keep this
LOW (FALSE) pulldown current to less than 10mA.
Please note that Power Good is brie?y false during Sequence ramp-up.
Ignore Power Good while in transition.
www.murata-ps.com/support
MDC_LSN2.C01 Δ Page 13 of 15
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
LSN2-T/30-D12-C CONV DC/DC 150W 30A 0.8-5V SIP
LSS-T/10-W12-C CONV DC/DC 60W 10A .6-6V SIP
LTM4600HVIV#PBF IC DC/DC UMODULE 10A 104-LGA
LTM4600IV#PBF IC DC/DC UMODULE 10A 104-LGA
LTM4601AHVEV#PBF IC DC/DC UMODULE 12A 133-LGA
LTM4601AIY#PBF IC DC/DC UMODULE 12A 133-BGA
LTM4602IV#PBF IC DC/DC UMODULE 6A 104-LGA
LTM4603HVEV#PBF IC DC/DC UMODULE 6A 118-LGA
相关代理商/技术参数
LSN2-T/16-W3N-C 制造商:Murata Power Solutions 功能描述:DC/DC Converter
LSN2-T/16-W3NG-C 功能描述:DC/DC转换器 52.8W5V/0.75-3.3V16A RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸:
LSN2-T/22-D12-C 功能描述:DC/DC转换器 12Vin 0.8-5Vout 22A 112W NonIso DOSA-SIP RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸:
LSN2-T/22-D12G-C 功能描述:DC/DC转换器 12Vin 0.8-5Vout 22A 112W Power Good Out RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸:
LSN2-T/22-D12NB-C 制造商:Murata Power Solutions 功能描述:Module DC-DC 1-OUT 0.8V to 5V 22A 112W 12-Pin SIP
LSN2-T/22-D12N-C 功能描述:DC/DC转换器 12Vin 0.8-5Vout 22A 112W Neg polarity RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸:
LSN2-T/22-D12NG-C 功能描述:DC/DC转换器 12Vin 0.8-5Vout 22A 112W PowerGood NegPl RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸:
LSN2-T/30-D12 制造商:MURATA 制造商全称:Murata Manufacturing Co., Ltd. 功能描述:Non-isolated, DOSA-SIP, 6/10/16A Selectable-Output DC/DC Converters